Installation Of A Hard Drive - Nexto Di ND2901 User Manual

Warning
● The case of the hard drive must not get damp or wet. Protect the
device from humidity and water, from sun, excessive heat (>113°F)
or cold (<32ºF), dust and dirt.
● When the product is brought from a cold place into a warm room,
condensation may form. This could damage the product. Always let
the product get to room temperature before use or before
connecting the AC power adapter unit. This can take several hours.
● Do not use in tropical climate conditions.
● The AC power adapter unit complies with safety class II. As a voltage
source only a proper power socket of the public power supply
system may be used. Note the input voltage/frequency imprinted on
the AC Adapter. It must correspond to the voltage/frequency of the
power outlet. The AC power adapter is equipped with an input
voltage range of 100 ~ 240V, 50/60Hz. Adapters may be necessary
for use in countries other than the US.
● The product is not a toy and should be kept out of reach of children.
● Do not place liquid near the product. Liquid could get inside the
housing and cause a fire or electric shock. In case of fire damage or
short circuit, de-energize the respective socket (e.g. turn off circuit
breaker) and only then pull the AC power adapter unit from the
socket. Do not attempt to use the product! Take it to your dealer
for repair immediately.
● Never touch the AC power adapter unit when your hands are damp
or wet.
● In industrial facilities, safety regulations for electrical equipment
and facilities must be observed. If the product is used at schools,
training facilities, or do-it-yourself/hobby shops, it should not be
handled unless supervised by trained, responsible personnel.
● Do not drop the ND2901 device.
Caution
● The product must not get damp or wet. This product is not a toy.
It contains fragile and swallowable glass parts, small parts, and a
rechargeable battery. Any use other than that described above may
damage the product. Read these operating instructions thoroughly
and carefully. The instructions contain important information for
installation, operation, and handling. Take note of all safety
instructions.
05
SYMBOLS USED IN THIS DOCUMENT

5. Installation of a hard drive

The ND2901 is delivered without a hard disk drive. A user can install a 2.5"Serial
ATA (SATA) hard disk drive with 9.5mm height.
Caution
● ND2901 does not support Parallel ATA (PATA) or IDE hard disk drive.
● DO NOT USE SSD(Solid State Disk) with ND2901. Use with Hard Drive
only. ND2901 cannot provide enough power to run the SSD.
NextoDI recommends using 5400rpm hard drive.
● Disconnect all cables and remove any memory cards from the ND2901
before installing a hard drive. The ND2901 should be in power "off"
state.
Remove the cover on the lower side.
Insert a 2.5" SATA hard disk drive.
The protective film must be placed between the
circuit board and the hard disk drive.
Make sure that the pins of the hard drive are
inserted exactly in the socket board inside the
case.
Put the cover on again. Make sure to observe the
correct orientation. The larger foam part on the
inside of the cover should face in the direction of
the power socket/USB port.
Reference
● The hard drive must subsequently be
formatted. For this purpose, see chapter 10.
06
FORMATTING THE HARD DRIVE