Connecting The Camera To A Computer - Minolta DiMAGE F200 Instruction Manual

Connecting the camera to a computer

Confirm the battery has sufficient power before connecting the camera to a computer, the full-battery
indicator should be displayed on the monitor and data panel. The use of the AC adapter (sold sepa-
rately) is recommended over the use of the battery. For users with Windows 98 or 98 Second Edition,
read the section on page 110 on how to install the necessary USB driver before connecting the cam-
era to a computer.
2
4 Insert the memory card into the camera. To change the memory card while the camera is con-
nected to a computer, see page 118.
5 Turn on the mode dial to any position to initiate the USB
connection. While the camera is connected to a computer,
the data-transfer screen will be displayed.
108 -
D
ATA TRANSFER MODE
1 Start up the computer. The computer must be on before connecting
the camera.
2 Remove the USB-port cover. Attach the smaller plug of the USB
cable to the camera. Make sure the plug is firmly attached. The
USB-port cover is attached to the body to prevent loss.
3 Attach the other end of the USB cable to the computer's USB port.
Make sure the plug is firmly attached.
• The camera should be connected directly to the
computer's USB port. Attaching the camera to
a USB hub may prevent the camera from
operating properly.
3