Continuous Advance - Konica Minolta DiMAGE A2 Instruction Manual

CONTINUOUS ADVANCE

Continuous-advance mode allows a series of images to be captured while holding down
the shutter-release button. Continuous advance acts like a motor drive on a film camera.
TIFF and RAW & JPEG image quality cannot be used. RAW cannot be used with UHS
continuous advance.
1
2
Continuous advance - captures a maximum of three images at 1.8fps. When
used with continuous autofocus, the camera adjusts the focus during the
series. The live image is briefly displayed between frames.
High-speed continuous advance - captures a maximum of three full-size
images at 2.7fps. The rate of capture decreases with images smaller than
3264 X 2448. Focus is locked with the first frame regardless of the focusing
mode. The monitor turns off during the series.
UHS continuous advance - captures multiple 640 X 480 size images at 7fps.
The approximate number of frames that can be captured at one time depends
on the image quality setting: extra fine - 100, fine - 160, standard - 180. The
digital zoom and flash cannot be used. Shutter speeds must be 1/30 second
or faster. Very bright light sources within the image may cause streaking.
Black areas caused by a loss of data may be apparent.
64
A
DVANCED RECORDING
Turn the function dial to the drive mode position
3
(1). Press the function button in the center of the
dial (2). Turn the front control dial to select the
continuous-advance drive mode (3). Use the rear
control dial (4) to switch between standard, high-
speed, and UHS continuous advance. Press the
shutter-release button partway down or press the
function button to set the mode.
4