VIESMANN Service instructions for contractors Vitocell 340-M/360-M Type SVKA Type SVSA Combi cylinder 750 and 950 litre capacity For applicability, see the last page VITOCELL 340-M/360-M Please keep safe. 5608 688 UAE 1/2012...
Repairing components that fulfil a ■ Legal instructions regarding the pre- safety function can compromise vention of accidents the safe operation of your sys- ■ Legal instructions regarding environ- tem. mental protection Replace faulty components only with original Viessmann spare parts.
Page 3
Installing non-author- ised components and making non-approved modifications or conversions can compromise safety and may invalidate our warranty. For replacements, use only orig- inal spare parts supplied or approved by Viessmann.
Index Index Commissioning, inspection, maintenance Steps - commissioning, inspection and maintenance.......... Further details regarding the individual steps............Parts lists Ordering parts...................... Overview of the assemblies................. Cylinder assembly....................Thermal insulation assembly................10 Commissioning/service reports................ 11 Product characteristics..................12 Accessories Specification for immersion heater............... 13 Certificates Declaration of conformity..................
Commissioning, inspection, maintenance Steps - commissioning, inspection and maintenance For further information regarding the individual steps, see the page indicated Commissioning steps Inspection steps Maintenance steps Page • 1. Filling the DHW cylinder..........• • 2. Inspection and maintenance........... • •...
Commissioning, inspection, maintenance Further details regarding the individual steps Filling the DHW cylinder 1. Fill the DHW cylinder from the DHW 2. Check the fittings on the heating side. water and DHW sides for leaks and retighten if required. Note Initially fill the cylinder from the DHW 3.
Commissioning, inspection, maintenance Further details regarding the individual steps (cont.) Cleaning the inside of the DHW cylinder 1. Drain the cylinder from the DHW 4. Fully drain any cleaning agent. side. 5. Thoroughly flush the indirect coil on 2. Disconnect the cylinder from the the DHW side after cleaning.
Parts lists Ordering parts The following information is required: Standard parts are available from your ■ Serial No. (see Vitocell A type plate) local supplier. ■ Assembly (from this parts list) ■ Position number of the individual part within the assembly (from this parts list) Overview of the assemblies A Type plate...
Commissioning/service reports Commissioning/service reports Commissioning Service Service date: Service Service Service date: Service Service Service date: Service Service Service date: Service Service Service date:...
Product characteristics Product characteristics Cylinder capacity kWh/24 h 1.49 1.61 Standby heat loss with 45 K temperature differential (standby capacity) (solar capacity) Standard parameter...
Accessories Specification for immersion heater 6 kW electric immersion heater Rated output in standard mode Rated voltage 3/N/PE 400 V~/50 Hz Rated current Type SVKA/SVSA, 750 litres Heat-up time from 10 to 60°C Capacity that can be heated by the immer- sion heater Type SVKA/SVSA, 950 litres Heat-up time from 10 to 60°C...
The product characteristics determined as system values for the products Vitocell 340-M and Vitocell 360-M as specified by the EnEV [Germany] as part of EC type testing according to the Efficiency Directive (see table on page 12) can be used for the energy assessment of heating and ventilation equipment to DIN V 4701-10.
Page 16
Applicability Serial No.: 7495750 7495751 7495752 7495753 Viessmann Werke GmbH&Co KG D-35107 Allendorf Telephone: +49 6452 70-0 Fax: +49 6452 70-2780 www.viessmann.com...
Need help?
Do you have a question about the Vitocell 340-M and is the answer not in the manual?
Questions and answers