Rx Unit Access; Pa Unit Access - Vertex VXR-5000 User Manual

RPP Programming Software Instruction
VXR-5000
o
This completes normal disassembly for
servicing, to completely remove the unit,
disconnect the TX coaxial cable from the
BNC jack, and unplug the two cables lead-
ing to the CNTL Unit from J3001
&
J3002.
TX Unit
RX Unit Access
o
This unit is removed in the same manner
as described for the TX Unit. Control Unit
cables connect to J4001
& J4002.
To com-
pletely remove the unit, disconne.ct the co-
axial cable leading to the
RX ANT
Jack from
the ENe jack.
RX Unit
Instruction lrIanual
PA Unit
Access
o
First remove the 6 large screws affixing the
heat sink/?A Unit to the chassis. Loosen
the heat sink unit from the chassis.
;
1~
o
Next remove the TX ANT cable from the
BNe COnT'.ector on the TX Unit, and re-
move the 8 screws affixing the top cover to
expose the PA Unit (see below).
TX PA Unit
'~-17