1. Manuals
  2. Brands
  3. Sola Manuals
  4. UPS
  5. UPS 325
  6. User manual

Sola UPS 325 User Manual

400 va, 750 va and 1000 va
Hide thumbs
Table of Contents

Advertisement

Quick Links

USER GUIDE
ups 325
400 VA, 750 VA and 1000 VA
Company
A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UPS 325 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Sola UPS 325

Summary of Contents for Sola UPS 325

  • Page 1 USER GUIDE ups 325 400 VA, 750 VA and 1000 VA Company...
  • Page 2 Important Notice The UPS ground (earth) conductor carries leakage current from the loads in addition to any leakage current generated by the UPS. This UPS generates no more than 1 mA of current. To limit the total leakage current to 3.5 mA, the load leakage must be limited to 2.5 mA. The three-wire receptacle that you plug the UPS into must have a good (low-impedance) ground (protective earth) connection to provide a safe path for leakage current.

  • Page 3: User Guide

    ® u p s 325 400 VA, 750 VA and 1000 VA User Guide STM-0302B © Copyright 1999, Best Power. All rights reserved.

  • Page 4: If You Have A Question

    Section). SOLA’s service technicians have in-depth knowledge of the UPS and power problems. SOLA may request that you return the UPS. If this happens, we will give you a Return Authorization (RA) number. When you return a SOLA 325 to the factory for any reason, please use the original packing material in which your unit was shipped to you.

  • Page 5: Table Of Contents

    SOLA Australia Offices ........

  • Page 6: Safety Instructions

    For assistance, call SOLA Service or your local SOLA office. If the SOLA 325 unit has been damaged during shipment, call your vendor immediately. If the SOLA 325 unit is stored, the batteries should be recharged every 6 months. If stored above 25 Celsius, recharge the batteries more often.

  • Page 7: Ups Features

    325 UPS Features The SOLA 325 provides protection against power problems, including power outages, brownouts and sudden increases in power. It also provides spike suppression and line noise filtering to protect your equipment. Front panel LEDs and an audible alarm keep you aware of the unit’s status.

  • Page 8: Quick Startup

    325 Quick Startup If your SOLA 325 UPS has a removable power cord, connect the power cord to the back of the unit. Plug the UPS into a wall outlet. Even if the UPS is turned off, the battery charger will operate when input power is applied to the UPS.

  • Page 9: Installing Checkups Ii Software

    325 Installing CheckUPS II Software Your UPS is supplied with a CD-ROM and communications cable to install and operate CheckUPS II. To install CheckUPS II on your computer, follow the installation instructions enclosed with the CD-ROM. SO L A N e v e r S t o p s I n n o va t in g...

  • Page 10: Symbols, Leds And Audible Alarms

    See Table 3 for information on beep coding. In the figure below, bucking means that SOLA 325 is reducing high input voltage, and boosting means SOLA 325 is increasing low input voltage.
  • Page 11 See Tables 3 and 4. If your SOLA 325 runs on batteries frequently because the input utility line varies often, you may want to adjust your SOLA 325 to accept wider voltage variations before switching to batteries.

  • Page 12: Troubleshooting

    2. UPS Fault 2. Phone SOLA Service. * If the SOLA 325 battery does not recharge after 24 hours in the 3-beeps/5-minute alarm state, the alarm changes to 3 beeps/10 seconds, indicating the battery must be replaced. S OL A N e v e r S top s I nn ov a tin g...

  • Page 13: Replacing The Batteries

    325 Replacing the Batteries SOLA 325’s batteries are user-replaceable and can be replaced while the SOLA 325 has AC input applied and powers the load. This means that, if necessary, you can replace the batteries while the UPS is running. Before you replace the batteries, make sure that you read the safety information below.

  • Page 14: Battery Replacement Instructions - 400Va Model

    Option: You may switch off and unplug the protected load equipment from the SOLA 325. Then, turn off the SOLA 325 and disconnect the line cord. On the bottom of the SOLA 325, remove the Phillips screw at the top of the battery door and slide the door off.

  • Page 15: Battery Replacement Instructions - 750Va And 1000Va Models

    Dispose of old batteries properly If you followed the option in step 2: Reconnect the line cord to the SOLA 325 and turn the unit on. Reconnect the load equipment. Switch on the protected load equipment one piece at a time.

  • Page 16: Communication Port

    325 Communication Port The SOLA 325 is plug-and-play compatible with Windows 95 and 98. CheckUPS II management software is provided with the SOLA 325. An interface cable for the following systems is also provided. SCO UNIX/XENIX UNIX and Compatible Systems OS/2 Windows 3.X, 95 and NT...

  • Page 17: Specifications

    325 Specifications Line Transient Protection: Passes ANSI/IEEE C62.41 Category A testing. Safety Compliance: TUV/GS Listed, AS3260 EMC Compliance: CISPR 22 Class B, Vfg 243-91/46-92 B, EN55022, CE Mark Self-certified to: CE Marking Directive 93/68/EEC, Low Voltage Directive 73/23/EEC, C-Tick, AS3548.

  • Page 18: Warranty

    Operating Temperature: 0° - 40° C. Storage Temperature: -15° to +50° C. Battery life is reduced above 25 ° C. If the SOLA 325 unit is stored, the batteries should be recharged every 6 months. If stored above 25° Celsius, recharge the batteries more often.
  • Page 19 325 3. Any modification made to the product other than those made by SOLA or its authorised representative may cause the Warranty to be void. 4. For units up to 3kVA that are installed as a portable device, the Warranty covers repair or replacement...
  • Page 20 This page intentionally left blank.

  • Page 23: Appendix A: Adjusting Voltage Settings

    • Nominal Voltage — The normal voltage the UPS is programmed to expect, and the nominal UPS output voltage under line loss conditions. • Buck — The input voltage at which the SOLA 325 decreases voltage before providing output because the input voltage is too high.
  • Page 24 The new values will take effect save your after the display returns to normal mode. changes. Table 5: Voltage Settings for SOLA 325 Models (400, 750, and 1000 VA) To Inverter Nominal To Inverter...

  • Page 25: Sola Australia Offices

    325 SOLA Australia Offices Head Office - Melbourne SOLA Australia Ltd. 13 Healey Road Dandenong VIC 3175 Phone: 61-3-9706-5022 Fax: 61-3-9794-9150 Email: sola@solaaust.com.au National Service and Repair Centre Free Call: 1800 034 401 (except Melbourne) 9768 3105 (Melbourne only)
  • Page 26 2-year warranty against defects in material and workmanship. This product is backed by over 60 years of pride and integrity. We are sure you will agree, there is no substitute for a SOLA. SOLA is one of the Best group of companies Did you know that SOLA also makes: •...

Table of Contents