advanced scale models DeHavilland DH88 Comet Instruction Manual page 4

STEP 7:
Using 5 minute epoxy, secure the vertical fin in
position making sure that it is square in relation to
the tailplane. After the epoxy has set, run a bead of
medium CA around the outer joint.
STEP 8:
Using the supplied hinges, fit
the elevators and rudder in
place by applying a few
drops of thin CA adhesive to
both side of the hinge.
STEP 9:
Feed aileron extension leads though the centre
wing panel. A hole approximately 16cm from the
leading edge will have to made in the center section
for the leads to exit.
STEP 10:
Then fit the aileron servos to the
removable hatches with some
double side foam tape. For
extra security we would suggest
fitting additional hardwood
mounting blocks.
STEP 11:
Measure and mark the half way
point of the alloy wing joiner
tube.
Glue the alloy tube into one of
the wing panels. Only insert
tube up the half way point.
Let epoxy set thoroughly before moving to the next step.
_____ Page 4 _____