Standby; System Reset - Harman Kardon OMNI 10 Owner's Manual

Standby

To conserve electricity, the Omni 10, Omni 20, or
Adapt will automatically enter Standby mode after
10 minutes, if no audio is playing and no buttons
are pressed. The Link button LED will turn amber,
and the amplifiers will turn off. Wi-Fi, Bluetooth®,
and Aux-in will continue to be monitored during
Standby mode. You can wake your product up
again by pressing the Link button, or by beginning
to play audio to it via Wi-Fi, Bluetooth®, or Aux-in.
If an audio signal is detected, the product will
automatically wake up.
Note: Since the product will automatically wake up
from Standby mode if Aux-in audio is played, you
must pause or stop playback on your connected
Aux-in source device to allow your Omni 10, Omni
20, or Adapt to enter standby.
You may manually enter Standby mode by pressing
and holding the Play/Pause button on the top
panel of the product for 3 seconds.
Note: The speaker in a 'Stereo pair' which is not
the Master will automatically enter standby when
there is no audio playback.

System Reset

To restore your product to factory default settings,
press and hold the reset button for 5 seconds. All
Wi-Fi settings, room names and groups, volume
settings, and paired Bluetooth® devices will be
forgotten. You can also use this method to enter
Wi-Fi setup mode (see Setting up Wi-Fi via the
Harman Kardon Controller app (iOS®), on page
12, or Setting up Wi-Fi via the Harman Kardon
Controller app (Android™), on page 20)
41
Omni 10
Omni 20
Adapt