Wps - Harman Kardon OMNI 10 Owner's Manual

WPS

WPS is a simple way to connect your system to your home network. To confirm whether your router
supports WPS, look for the WPS logo
and Adapt support both WPS-PBC and WPS-PIN modes. If your router supports it, WPS-PBC is the
simplest way to set up your Wi-Fi connection.
To connect to your home network via WPS-PBC mode:
1. Press the WPS button on your router.
2. Within one minute, press the WPS button on the Omni 10, Omni 20, or Adapt for less than
two seconds.
3. The Link button LED will quickly flash for up to one minute. Once the LED stops flashing and
turns solid white, your product is connected to your home network.
To connect to your home network via WPS-PIN mode:
1. Use a web browser to navigate to your home router's setup page.
2. Press and hold the WPS button on the Omni 10, Omni 20, or Adapt for 3 seconds.
3. Enter 12345670 into the WPS-PIN section of your home router's setup page.
4. The Link button LED will quickly flash for up to one minute. Once the LED stops flashing and
turns solid white, your product is connected to your home network.
25
or the letters WPS on your router. The Omni 10, Omni 20