Compartimiento De Discos Y Discos Compactos - Blaupunkt CDC-RF6 Owner's Record

Before Installing and Testing (continued)
Transport Lock Screws
The mechanism in the CD changer is "locked" into place during
shipment by three transport screws. Be sure to remove the screws prior
to testing the system and installation.
To keep dust out of the unit, which could cause a malfunction, place the
enclosed seals over the screw holes after the Transport Lock Screws
have been removed.
Reset Button
A Reset Button is located on the front panel of the Commander
and must be activated with a pen tip or other thin object, as it is
recessed to prevent accidental engagement. Press the Reset
Button under the following circumstances:
1. After connections have been made for initial testing.
2. After installation, when all wiring is completed.
3. If abnormal disc operation is encountered, the Reset Button
should be pressed to clear the system to return to normal
operation.
4. After disconnecting and reconnecting the car battery, etc.
ID (Identity) Switch for 2nd CD Changer
To connect a second CDC-RF 6 changer, you
must use Blaupunkt's CDC-RF BRIDGE,
which is sold separately. When an
additional CD changer has been connected
using this unit, the ID switch is used to
indicate the number of each respective
changer unit.
The ID switch is initially set to "1" when
l
shipped.
When only one changer is connected, the
l
switch should be set to "1 'I.
When two changers are connected, one
l
of the unit's switches should be set to "2"
using a ballpoint pen or similar fine-tipped
Setting the Radio Frequency
must select and test the radio frequency that the changer will use before
You
you mount the FM Modulator.
Set the radio frequency setting to 89.1 using the switch on the back of the
FM Modulator. Test the operation of the changer. (See page 15) If a clear
signal cannot be obtained on 89.1 MHz, change the position of the
frequency-select switch to 88.7.
The radio sensitivity is slightly reduced when the FM Modulator is connected.
2
1
C D
1 st unit
2
C D
2nd unit (additional changer unit)