Table of Contents
Advertisement
The following check will assist in the correction of most problems that you might encounter with your
unit. Perform the checks described below before contacting your Blaupunkt dealer.
Symptom
No Power
No Sound
No Sound,
Two-speaker System
Magazine cannot be
installed.
Selected disc does
not play.
Noise is heard
during playback or
sound is
intermittent.
Fuse Replacement
When replacing the fuse, be sure to use one with the correct amperage, which will be stated on the
fuse case. Never use a fuse that has a stated amperage exceeding the one supplied for this unit, as
this could cause malfunction and serious damage to the unit.
Moisture Condensation
On a rainy day or in a very damp area, moisture may condense on the lens inside the unit. Should this
the moisture has evaporated.
Cause
Fuse blown.
Improper connection.
Improper connection.
Fader set to non-existent speakers.
Attempt made to insert magazine
improperly.
Disc is loaded incorrectly.
Large scratches on disc or warped
disc.
Extemely dirty disc.
Transit Screws still in place.
Anti-Vibration Switch set in wrong
position.
Remedy
Replace with a fuse of the same type
and rating as the original.
If the fuse blows again, consult with
your dealer.
Check connections.
Check connections.
Set fader to center position to
determine if speakers are wired for
front or rear setting.
Insert it in proper direction.
Load disc with play side facing up.
(Printed side should face down).
Compare sound with another disc. If
second disc is
sound from
acceptable, first disc is defective.
Clean disc.
Remove 3 screws on bottom of unit
and try again.
Set the Anti-Vibration Switch to the
correct position (See page 7-l 1).
17
Hide quick links:
Advertisement
Table of Contents
