Table of Contents
Advertisement
4.Re-assemble the case in the reverse order.
A new 10-watt bulb can be obtained at
Lay the appliance on its back. Remove the 8
screws (1). Remove the door, together with the two
hinges (2), from the housing.
Remove the two cover caps (3) from the housing
and place them in the open hinge holes in the
housing. Place the bottom righthand hinge in the
top left of the door and the top righthand hinge in
the bottom left of the door and hang the door on its
hinges in the open cover cap holes in the housing.
Secure the hinges and cover caps with the 8
screws.
Check that the door closes easily and is sealed
properly.
Figure 7.
Figure 7.
1.
1.
3.
The length of the hinge stretching out of
the refrigerator door must be 80mm.
7
D
ometic.
(Fig.7)
2.
2.
4.
Distance to cupboard door (A)
1. When closed, the cupboard door (A) must not lie
against the rest of the surrounding cupboard area
(distance 1-2mm).
2. There must be a distance of 6-8mm between
the cupboard door and the miniBar.
Remove the two screws (1) from the upper hinge of
the door.
Pull the door together with the hinge away from the
housing and up off the lower hinge bolt (2-3).
Remove screws (4) and pull off the frame edge (5).
Slide the decorative panel (6) out of the door frame
and insert the new panel (7), so that the upper edge
of the panel runs exactly parallel to the upper edge of
the frame. A new panel can be inserted more easily
into the upper edge of the frame when the two corners
are cut off by approx. 5× 5 mm (8). Put the frame edge
(5) back in place and secure with screws.
Place the door on the lower hinge (9), slot the upper
hinge into the opening, press together with the door
against the housing and secure with the two screws
(11).
1.
mm
A
2.
mm
(Fig. 8-10)
- Quick Links:
- Temperature Regulation
Hide quick links:
Advertisement
Table of Contents
