Table of Contents
Advertisement
Emergency zone: Detecting the space like Emergency area (such as emergency distress, medical rescue, gas leakage and
fire alarm, etc., this zone keep 24-hour monitoring status automatically. Generally use panic button, wireless gas sensors and
wireless smoke sensors.
3. Modes of arming
"Away Arm" mode：Once any detectors in perimeter zones or motion zones get triggered, the host will alarm immediately and
meantime dial "#" automatically.
"Home Arm" mode：Once any detectors in perimeter zones get triggered, the host will alarm immediately and meantime dial "#"
automatically. It will not alarm after any detectors in the motion zone are triggered.
4. How to operate the alarm host
Preparation
1. Insert SIM card properly.
2. Fix the antenna
3. Connect the telephone cable: connect the telephone cable of telecommunication to "Tel in" port on the alarm host, then
use the telephone cable attached in the package to connect "Tel out" port and telephone set.
4. Connect power: connect the power adaptor to DC port of the alarm host first, then plug it to the AC socket.
5. Turn on the backup battery
6. Check and see if GSM signal is good enough
Type
2-Band
（900/1800 MHZ）
4-Band
（850/900/1800/900 MHZ）
Signal level status
When standby, press"▲"or"▼"and you can see the signal status as below.
XX: 0 .....31 indicates the signal from weak to strong,99 indicates unknown.
YY: Indicates signal status, OK is good, No is a little weak and need to adjust installation position.
Press "ESC" to get back for standby status. Or get back to standby status automatically after 30 seconds without no operation.
Note: If SIM card is not insert properly, it will shows:
How to program
Notes:
The host will exit programming mode if without any operation within 30 seconds
It will exit to the previous menu if press "ESC"
If enter codes by mistake for 3 times, the host panel will resume to the standby mode
you can press "▲▼" to adjust programming info. Or to find alarming info.
1. Menu preview
Main menu
Sub-Menu1
Set Time
Set time
Set Date
Set Date
Call Center
Auto-dialer#‟s
Personal Nbr
Entry Delay
Entry delay
Exit Delay
Exit Delay
Siren off
Siren On/Off
Siren on
GSM Signal OK
Signal indicator keeps flash about
every 2 seconds
Signal indicator keeps flash about
every 3 seconds
Sub-Menu2
Sub-Menu3
Call by phone
SMS reportng
Emergency
Perimeter siren
siren
Signal is not normal or SIM card not
inserted properly
Signal indicator keeps on
Signal indicator keeps flash about
every 1 seconds
Signal Level:
NO SIM CARD:
Sub-Menu4
Sub-Menu5
Motion siren
XX YY
XX YY
Remark
Hour/minute/second
Year/Month/Day/Week
Alarming phone number,
Group 2~5 for personal
Time delay for enter
Time delay for exit
Duration time
of alarming sound
Advertisement
Table of Contents
