Table of Contents
Advertisement
Operating power：3.7V Li-Ion battery.
Emitting frequency: 433Mhz
Emitting distance: ≥100M（In open area）
Service life: ≤1 year
Installation and usage
1. Fix the base on the wall
2. Then fasten the main part with the base.
3.
Change batteries when indicator flashes frequently in green.
How to program
Please refer to the descriptions of 【Program Sensor】 (The doorbell button has its fixed zone number---"20")
Note:
You can only add 1 wireless doorbell button each time, totally 4 available to be added.
Each serial number is available to study 1 wireless doorbell button, the latter configured wireless doorbell button
will be workable and the former one becomes not workable automatically.
Table 6 : Preview of how to activate and deactivate "Basic accessories (Wireless)" and "Optional accessories (Wireless)"
Type
Remote
Door
Basic
Sensor
accessories
(Wireless)
Wide-Angle
PIR Sensor
Indoor siren
Gas alarm
Optional
Smoke
Accessories
Sensor
(Wireless)
Outdoor
Siren
V. Common Problems and Solutions
Symptoms of Faults
The alarm host can‟t fully record
in a position of 1.6m above the ground.
Max. no. to
Zone
be
No.
programmed
1) 【SET +Programming code + "▲▼"
"Program sensor" + ENT + "
ENT + "
sensor" + ENT 】 （The screen would say
00、 01
8
learning）
2) Press any key on the remote twice
successively,
display "Success"；
1.Same as above
11~20
4
2.Trigger the door sensor twice
successively
1.Same as above
2.Trigger the PIR sensor by pressing
21~30
4
"Learning Emitting Switch" on the panel
twice successively
1.After connecting to the power, press the
"learning switch on the side of the siren
2. Press" " key on the alarm host, disarm
——
N/A
by keypad on the alarm host after about 5
seconds.
3. Lights of the siren flashes 5 times and
1. Same as above
02~10
4
2. Trigger gas alarm by releasing gas,
the host LCD will display "Success"
1.Same as above
02~10
4
2.Trigger smoke alarm by releasing
smoke, the host LCD will display "Success"
——
N/A
Same as wireless indoor siren
Possible Cause
Did not keep pressing the record all
the time while recording
How to activate
" + X + ENT + "▲▼""Activate
the
host
then off indicates successful activating
Solution
Keep pressing the record all the time while
recording
How to deactivate
" + Y Y +
1) 【SET +Programming code + "▲▼"
"Program sensor" + ENT + "
+ ENT + "
"▲▼"Delete sensor" + ENT 】
2) The alarm host will beep once and
LCD
will
press ESC to exit.
Same as above
Same as above
After connecting to the power, keep
pressing the "Learning" switch on the
side of the siren for 5 seconds and
release, lights on the siren flashes 1
time and then off indicate successful
deavtivating
Same as above
Same as above
Same as wireless indoor siren
" + Y Y
" + X + ENT +
Advertisement
Table of Contents
