Sliders - Yamaha CP4 Stage Reference Manual

Sliders

The CP4 STAGE and CP40 STAGE are each equipped with two sets of sliders — the Part sliders and the
MASTER EQUALIZER (EQ) sliders.
Part sliders
Located on the left of the control panel, the Part sliders are used to adjust parameter levels for individual
Parts. There is one slider for each of the instrument's Parts, and they can be used to adjust three parameters
— volume, chorus send, and reverb send. To change the parameter currently being adjusted, press the
[SLIDER FUNCTION] button located to the right of the sliders the required number of times. Moving the
sliders away from you increases the level of the current parameter and vice-versa.
NOTE
For more details on using the Part sliders, refer to the Quick Start Guide section of the Owner's Manual.
NOTE
Operating the Part sliders also changes the settings of the Volume, ChoSend, and RevSend parameters from the Performance
Part Edit area's Play Mode screen
Parameter level increases
Parameter level decreases
MASTER EQ sliders
The master EQ is used to adjust the overall tone of the instrument, and the MASTER EQ sliders control the
gain in individual frequency bands. Located on the right of the control panel, each of these sliders is
assigned to a different frequency band. Moving a slider away from you increases the gain in the
corresponding frequency band and vice-versa.
5 CP4 STAGE/CP40 STAGE Reference Manual
Design of the CP4 STAGE & CP40 STAGE > Controllers
(page 17).
(Illustration shows the CP4 STAGE.)
Gain increases
Gain decreases
(Illustration shows the CP4 STAGE.)