Connecting a VCR
VCR Rear Panel
Audio Cable (Not supplied)
Video Cable (Not supplied)
Antenna Cable (Not supplied)
If you have a "mono" (non-stereo) VCR, use a Y-connector (not supplied) to connect to the right and left audio input jacks of the
TV. Alternatively, connect the cable to the "R" jack.
If your VCR is stereo, you must connect two cables.
Each VCR has a different back panel configuration.
When connecting a VCR, match the color of the connection terminal to the cable.
When connecting to AV IN 1, the color of the AV IN 1 [Y/VIDEO] jack (Green) does not match the color of the video cable (Yellow).
TV Rear Panel
2
1
English - 5
Unplug the cable or antenna from
1
the back of the TV.
Connect the cable or antenna to the
2
ANT IN terminal on the back of the
VCR.
Connect an Antenna Cable between
3
the ANT OUT terminal on the VCR
and the ANT IN terminal on the TV.
Connect a Video Cable between the
4
VIDEO OUT jack on the VCR and
the AV IN 1 [Y/VIDEO] jack on the
TV.
Connect Audio cables between the
5
AV IN 1 [R-AUDIO-L] jacks on the
TV and the AUDIO OUT jacks on
the VCR.
Press the SOURCE button on the
6
remote control until you see the VCR
signal (see "To Select the Source"
on page 10).