Advertisement
• Mounting the Speaker to the Optional Bracket WCB-12 or TMB-1
1.
Replace speaker mounting screws (M5 x 15) of the
WCB-12 or TMB-1 with the screws (M5 x 20) supplied
with the speaker.
Note: Speaker mounting screws of the WCB-12 or
TMB-1 cannot be used for mounting the
speaker.
2.
Mount the WCB-12 or TMB-1 to the wall, desk or other
desired place.
3.
Assemble the speaker.
(Refer to "Method A" in the section "Wall or Ceiling
Mounting.")
LED LAMPS
Three LED lamps installed at the three corners of the front grille light when the speaker receives an audio
signal from the amplifier, with their brightness level varying in response to strength of sound reproduced from
the speaker. The lamps do not light when the sound volume is low.
Tips: When it is not desirable that the lamps light, disconnect terminal connection between the speaker and
LED protection circuit located on the reverse side of the baffle board.
SPECIFICATIONS
Model No.
Enclosure
Internal Speaker
Power Handling Capacity
Rated Impedance
Ounput Sound Pressure Level
Frequency Response
Color
Weight
Note: The design and specifications are subject to change without notice for improvement.
• Accessories
Rubber bushing ................................. 3
Screw ................................................. 2
F-10W
F-10B
15 W (continuous pink noise)
45 W (continuous program input)
8 Ω
White
Black
F-10WM
Sealed type
10 cm cone speaker
100 V line: 3.3 kΩ (3 W), 2 kΩ (5 W)
70 V line: 1.7 kΩ (3 W), 1 kΩ (5 W)
88 dB (1 W, 1 m)
100 – 18,000 Hz
White
1.5 kg
Flange nut .......................................... 2
Washer .............................................. 2
F-10BM
5 W (rated input)
Black
133-01-233-6A
Advertisement
