Maintenance - DeWalt DCS371 Instruction Manual

FIG. 10
RECOMMENDED CUTTING POSITIONS
YES NO
YES NO
YES NO
7. Whenever possible, hold the saw fi rmly in both hands. If the optional
YES NO
brush, brush cap and blade guard assembly must be installed for
one-handed use.
NOTE: The guard assembly is available at extra cost from your local
dealer or authorized service center.
Tips for Better Cutting
YES NO
The following recommendations should be used as a guide (refer
to Figure 10). Results may vary with the operator and the particular
material being cut.
• Never twist the band saw blade during cutting operation.
• Never use liquid coolants with portable band saws. Use of liquid
• If excessive vibration occurs during the cut, ensure that the material
YES NO

MAINTENANCE

turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
Lubrication
Self-lubricating bearings are used in the tool and periodic relubrication
is not required. In the unlikely event that service is ever needed, take
your tool to an authorized service location.
15
blade guards (Fig. 8) are installed, the saw can be operated with
one hand. Keep your free hand clear of the blade area and do not
allow the saw to fall against the clamped or supported material or
your body when the cut is complete.
WARNING: To reduce the risk of serious personal injury, the
coolants will cause build-up on tires and reduce performance.
being cut is is securely clamped down. If vibration continues,
change the band saw blade.
WARNING: To reduce the risk of serious personal injury,