Table of Contents
Advertisement
Fan Speed Control... This option is not applicable to any current models. If option present,
10.
factory default setting of "80" MUST remain. Controllers Version .06 or newer will not
contain a FAN option.
Menu Codes
Description
[FLO]
No water flow
detected
[OFF]
System is off
(With arrow key depressed)
[CFI]
Celsius Fahrenheit
selection
[ULC]
User Lock Code
[ELC]
Enter Lock Code
[CFO]
Call Flex Options
[FAN]
Two speed fan control Programming Entry Point: This option is not applicable to
[LOC]
Entrance to Service
Menu
LEVEL-1 DISPLAY CODES
Displayed Code Message: Appears whenever the circulating
pump is off, or when the heater is not receiving correct
water flow.
Displayed Code Message: Appears whenever system is off,
and until temperature set point is raised above 60° F.
Programming Entry Point: Allows temperature read-out to
display either Celsius or Fahrenheit.
Programming Entry Point: When activated, steps to the next
menu level [ELC] (enter lock code).
Programming Entry Point: Allows end user to select a secret
code so only authorized persons can change heater settings.
Programming Entry Point: When activated, steps to the next
menu level [CFS] (Call or Flex selection)
any current model; leave at factory default of "80".
Service Entry Point: The [LOC] code allows service
personal the ability to enter a factory code and access
service adjustable parameters in the software that may
require calibration or adjustments. This menu is available
only to authorized service personnel.
END Level-1 (Owner Accessible) FEATURES
Function
11
Advertisement
Table of Contents
