Selecting Call / Flex Pump Options [Cfo] - Aquacal HP7 Operating/Service Instructions Manual

Aquacal hp7 microprocessor controller operating & service instructions

Hide thumbs

Table Of Contents

Table of Contents

5) With [ELC] displayed, use the Up or Down arrow keys to select a lock code

number. The factory set lock code is "17". Not depressing any buttons for 15-

seconds will allow the control to save the selection and return to the normal

operating mode. Pressing the Pool / Spa key will also save the selection and step to

the next menu parameter [CFO] (Call Flex Options);

6) Once the ULC option has been enabled, depressing any key will display [000]

(prompting the entry of the correct lock code number). To gain access to the

controller:

a) Using the Up⇑ arrow, scroll to the correct lock code number, then:

b) Press the Pool/Spa selector button...Current water temperature will be

displayed... Control settings can now be viewed and changed as desired.

c) After a period of approximately four (4) minutes, during which time no

buttons have been pressed, the controller will automatically return to the

locked mode. Provided the ULC selection is "1", the controller will always

fail-safe in the locked mode.

d) Without knowledge of the correct lock code number, with ULC enabled,

control adjustments will not be possible. Be certain to record your

security code in a safe place. The lock code number may be changed any

number of times by following the instructions detailed above in this section.

B. User Lock Code is Activated, but Pass Number is Not Known ("Back Door Entry"):

NOTE: Should the ULC option be enabled, and a lock code number other than the

factory default (17) be installed but is unknown, the following procedure

may be followed to re-gain controller programming access:

1) Turn off power to the heater at the breaker;

2) Simultaneously press and hold down the Up & Down arrows;

3) Continue holding arrow buttons down while turning the power back on;

4) Keep holding arrows down for approximately 15 seconds;

5) [CF1] will appear;

6) Go to [ELC] by pushing the Pool/Spa button. (Display will change each time P/S

button is pushed.);

7) Go to the up arrow, push it once. (The number that appears is the present, valid lock

code number);

8) It is recommend the access code be returned to the factory default: "17", before

exiting the program. By going back to [ELC] you can use the Up/Down arrows to

reset the lock code number back up or down to "17".