JVC KD-R900 Instructions Manual page 187

Category Menu items
Ring Color *
Fad/Bal * 4, *
Fader/Balance
Loud
Loudness
Volume Adjust
Subwoofer
HPF
High pass filter
* 3
Displayed only when USB Bluetooth Adapter (KS-UBT1) is connected.
* 4
If you are using a two-speaker system, set the fader level to <0>.
* 5
This adjustment will not affect the subwoofer output.
Selectable settings, [reference page]
3
• On
• Off
5
R6 – F6
L6 – R6
• Loud1/Loud2/
Loud3
• Off
Level –5 —
Level +5
(Initial: Level 0)
• LPF/Level
• Phase
Select the cutoff frequency to the front/rear speakers. Set this to match the LPF
settings.
• 62Hz/95Hz/
135Hz
• Off
: When a call comes in, the display will flash in blue.
• The display will change to the original color when you
answer the call or the incoming call stops.
When the unit receive a SMS, the display only illuminate
in blue.
: Cancels.
5 ∞
: Fad: Press / to adjust the front and rear speaker
output balance. (Initial: 0)
4 ¢
: Bal: Press /
speaker output balance. (Initial: 0)
: Boost low and high frequencies to produce a
well-balanced sound at a low volume level.
: Cancels.
: Preset the volume adjustment level of each source
(except FM), compared to the FM volume level. The
volume level will automatically increase or decrease
when you change the source.
• Before making an adjustment, select the source you
want to adjust.
• "FIX" appears on the display if "FM/FM-LOW" is
selected as the source.
4 ¢
: Press /
the subwoofer.
Off: All signals are sent to the subwoofer.
LPF 55Hz/LPF 85Hz/LPF 120Hz: Frequencies higher
than 55 Hz/85 Hz/120 Hz are cut off.
Turn the control dial to adjust the subwoofer output level.
Level 00 to Level 08 (Initial: Level 04)
: Turn the control dial to select the subwoofer phase.
0deg (normal) or 180deg (reverse)
: Frequencies lower than 62 Hz/95 Hz/135 Hz are cut off.
: All signals are sent to the front/rear speakers.
to adjust the left and right
to select the cutoff frequency to
Continued on the next page
SETTINGS 25