Heater Controls; Control Panel Layout; Buttons, Lights, And Display - Aquacal Heat Pump Installation Manual

Control Buttons, Indicator Lights, & Display
1) POOL / SPA SELECTOR – Selects either pool or spa thermostat.
2) COOLING INDICATOR LIGHT – Indicates unit is cooling. (Note: this light
nonfunctional with heat-only models.)
3) UP ARROW – Increases temperature setting. (Maximum setting is 104
4) DOWN ARROW – Decreases temperature setting. (Minimum setting is 45
5) HEATING INDICATOR LIGHT – Indicates unit is heating.
6) MODE SELECTOR – Used to select between the Heating, Cooling, Auto-
Changeover, and Off for Heat & Cool models. Used to select between Heating
and Off for heat-only models.
7) SPA INDICATOR LIGHT – Indicates heater is referencing spa thermostat.
8) POOL INDICATOR LIGHT – Indicates heater is referencing pool thermostat.
9) LED DISPLAY – Displays water temperature when no keys are being pressed.
Displays desired temperature when UP ARROW or DOWN ARROW is pressed.
Also displays operational, programming, and fault codes as applicable.
10) DESIRED TEMPERATURE LIGHT – Indicates temperature set point is being
displayed. Indicates temperature set point is being changed due to the UP
ARROW or DOWN ARROW being pressed.
11) WATER TEMPERATURE LIGHT – Indicates current water temperature is being
displayed.
12

HEATER CONTROLS

Control Panel Layout

(A
PPEARANCE
(
AS INDICATED BY CIRCLED NUMBERS
V M )
ARIES BY ODEL
)
F)
o
F)
o