Using The Remote Control - Mitsubishi Electric HC100 User Manual

Using the remote control

Operational range of the remote control
Front of projector
30˚ 30˚
Operate the remote
control within a distance
of 10 m from the projec-
tor, pointing the light
beam at the remote
control photo-sensor
(front or rear) of the
projector.
Reception angle
Vertical directions
Vertical directions (ceiling mount)
Rear of projector
30˚ 30˚
When operating the remote control, keep the distance
from the remote controller to the projector via the
screen within about 5m. The operable range of the
remote control, however, depends on the characteris-
tics of the screen.
20˚
10˚
20˚
http://www.pureglare.com.au
• Keep the remote control photo-sensor out of direct
sunlight or fluorescent lamp light.
• Keep the remote control photo-sensor at least 2 m
away from fluorescent lamps. Otherwise, the
remote control may malfunction.
• If there is an inverter-operated fluorescent lamp
near the remote control, the remote control
operation may become unstable. On this occasion,
stick the attached protection sticker on one of the
photo-sensors that is closer to the fluorescent
lamp.
20˚
10˚
20˚
EN-9