Table of Contents
Advertisement
To Change Temperature Format in Display from F to C or ˚C to ˚F:
Step 1: Enter "Set-UP Mode" by pressing both UP/DOWN buttons together for 3 seconds.
Step 2: Pressing either UP or DOWN buttons will toggle between ˚F or ˚C. Press "DONE" when selection is complete.
Display will revert back to DHW setpoint.
Pressing the "NEXT" button instead of "DONE" will enter the display to show "RMT" for Remote Firing Control. This
is for a future feature that is not currently used. The screen may show OFF or ON. If ON, it may display a number
for an address. Press DONE to exit this screen back to the DHW setpoint display.
NOTICE
9
Advertisement
Table of Contents
