Manually Controlling Your Xeed; Movements - LeapFrog Xeed Manual

–

2.3 Manually controlling your Xeed

The manual controls give you full control over all movement and actions of your printer when it is
not running a print job.

2.3.1 Movements

The movements of the printer are done at the control tab. Before moving the printer head and bed
manually it is highly recommended to home these first. This will make sure the printer does not
move in a direction it cannot move. Press both the X/Y- and Z-home button to home all three axes.
This means that the bed will be in its most upward position and the printhead is located in the left-
back corner of the printer.
After this you can use the arrows to move the extruder head or the printer bed.