SAVEO-SCAN-PKT-RCCD-BT
Getting Started
Switch on and Charge your Scanner
Please switch on and charge your scanner for 3~4 hours
before rst use.
Please note: LED indicator will remain red until scanner has
been paired with a device.
Operating Elements
Exit window
(For iOS Devices
ONLY)
Button to
raise and lower
ON-Screen
Keyboard
Scan/Power
Power Saving
On Button
button:
Press the button for
2~3 seconds to
LED Indicator
enter power saving
mode
Mini USB port
with protective cover
Charge the pocket scanner with mini USB cable.
1
Connecting via Bluetooth
Enable Bluetooth on your device
Go to your phone's homescreen and nd "Settings", then
"Bluetooth" and turn Bluetooth on.
Scan Pro le barcodes
Please note: The scanner should only be paired with one device
at a time. Before you pair your scanner to another device, please
rst unpair it from the device in use. Otherwise it will appear on
your list of "Available Devices" but will not connect. In this case,
please refer to "Unpairing your device" in this guide.
HID Pro le
After you scan the Bluetooth pro le barcodes below, your
scanner will become visible to Bluetooth enabled devices within
range.
Demo
A1
Demo
%H%I%D
A2
%B%R%C
2
Search for devices
Your phone will automatically search for devices, Saveo Scan will
appear as an external keyboard with a unique identi er number
(R-xxxxxx).
Select R-xxxxxx
Select scanner from "Available
Devices" and wait for pairing
to connect
process to complete.
Devices are now
Once "Connected" is
displayed, your device is
paired
paired to the scanner. Your
scanner is now ready to use.
Please note: devices only need to be paired once. When they are within
Bluetooth range they will automatically attempt to connect to each other. If
you wish to pair to another device it is recommended you rst unpair this
device.
You are now connected. Start scanning.
3