Page 1
SAVEO-RV2-Z12D Advanced Settings Reading Mode The default setting for reading mode is Single Scan. To choose another mode please scan the Demo appropriate barcodes below. Motion Sensor: Full Auto Mode Single Scan (Default) In this mode the scanner attempts to decode when In this mode the scanner attempts to decode when it the scan button is pressed.
Transmission Speed Demo Demo Transmission speed is dependent on your device. In order not to lose data please choose the correct speed. Mid Speed is the default. High Speed Transmission Ultra Low Speed 1 Transmission Demo %B%T%H Mid Speed Transmission Ultra Low Speed 2 Transmission (Default) Demo...
Symbologies Scan the following barcodes to enable/disable speci c symbologies. 1D Symbologies Demo Demo ENABLE DISABLE ENABLE DISABLE Discrete UPC-A Demo Demo Demo www.tec-it.com ENABLE DISABLE ENABLE DISABLE UPC-E CODABAR Demo Demo Demo ENABLE DISABLE ENABLE DISABLE EAN-8 Demo Demo Demo ENABLE DISABLE...
Page 4
2D Symbologies ENABLE DISABLE PDF 417 Demo Demo Demo ENABLE DISABLE Micro PDF 417 Demo ENABLE DISABLE Data Matrix Demo Demo ENABLE DISABLE Maxicode Demo Demo Demo ENABLE DISABLE Demo QR CODE DISABLE ENABLE Micro QR CODE Demo ENABLE DISABLE Demo Aztec Demo...
Page 5
SAVEO-RV2-Z12D Please scan the following barcodes in order Demo Full Charge Alarm - OFF %E%R%A Wait three seconds for con rmation sound before scanning the barcode below. www.saveoscan.com US PH: +1-720-257-7070 Email: info@saveoscan.com UK PH: +44 (0) 208 099 8071...
Page 6
SAVEO-RV2-Z12D QR Inverse This parameter sets the QR inverse decoder setting. Options are: • - the decoder decodes regular QR bar codes only. Regular Only • - the decoder decodes inverse QR bar codes only. Inverse Only • - the decoder decodes both regular and inverse QR bar codes.
SAVEO-RV2-M22D BEEP AFTER GOOD DECODE Scan a bar code below to select whether or not the decoder issues a beep signal after a good decode. If selecting Do Not Beep after Good Decode, beeper signals are issued during parameter menu scanning and to indicate errors.
Page 9
SAVEO-RV2-M22D Disable/Enable su x (”Enter”) Please scan the following barcodes (1 - 4) followed by “su x - disable” to disable su x from being appended to barcode data. You can then enable and disable su x (”Enter”) as desired with the two barcodes below (you do not need to scan barcodes (1 - 4) again).
Page 10
SAVEO-RV2-Z12D Transmit UPC-A Check Digit The check digit is the last character of the symbol used to verify the integrity of the data. Scan the appropriate barcode below to transmit the barcode data with or without the UPC-A check digit. It is always verified to guarantee the integrity of the data.
Page 11
SAVEO-RV2-M22D If connecting via Bluetooth, please unpair your device from the scanner before scanning the barcodes below. After resetting your scanner you will need to pair it to your device using the “Wireless BT Communication” barcodes on page 5 of the manual.