Hy-Gain 533 Instruction Manual

INSTRUCTION
MANUAL
The Hy-Gain
entire
has a front-to-back

Assembly

Unpack
Instructions
Ii st. Use the drawings
Boom-to-Mast Select
Bracket Assembly assemble
The inside
(ends
zontal.
See Figure
Element-to-Boom Select
each
Bracket Assembly
nuts,
Model CB-3 is a 3-element.
frequency range (26,9 to 27.3 mc).
ratio of 20 dB and front-to-side
the antenna from the carton
to help
the boom-to-mast body
using four 1/4"-20
holes will be used
not drilled) into boom-to-mast
Now, tighten the four
2.
the two sets of small element-to-boom
end of the boom in the pre-drilled
and lockwashers as shown
- 1 -
ORDER NO.
Model CB-3
CH, 3-element beam
beam des igned
lt develops a forward
ratio
and check the parts
you in identifying the parts.
and the boom-to-mast clamp
x 3/4" screws in the outside
later for the U-bolts. Insert
clamp. Holes in tubes
screws in the boom-to-mast
brackets
holes using 10-24 x 1-3/4"
in Figure 3.
533
PN 805661
to operate over the
gain of 8 dB,
of 40 dB.
against the parts
and loosely
holes only.
the boom tubes
must be hori-
bracket securely.
and mount them on
screws,