Advertisement
• Freezing Conditions: This is a cooling only air
conditioner. It is not designed for freezing
outdoor conditions. It must not be used in
freezing outdoor conditions.
• Remote Control: To ensure proper operation
when using the remote control, aim the remote
directly at the signal receiver on the air condi-
tioner.
~ The remote control has a signal range up to
20 feet.
~ Make sure nothing is blocking the remote
control signal from being received by the air
conditioner.
~ Make sure the batteries are installed correctly
and still have power.
• Cooling Mode: Use the COOL mode at Low,
Medium, High, or Auto Fan speed when cooling
is needed. Use the temperature ▲/▼ buttons to
set the desired temperature between 64°F and
86°F.
~ Once the temperature is set, the compressor
will cycle on and off to keep the room
temperature at the set temperature level. The
lower the set thermostat temperature, the
cooler the room will become. The higher the
set thermostat temperature, the warmer the
room will become.
~ For Normal Cooling - Set the Mode to Cool
and the Fan to High or Med with the termpera-
ture set in the middle.
~ For Maximum Cooling - Set the Mode to Cool
and the Fan to High with a lower set tempera-
ture.
~ For Quieter & Nighttime Cooling - Set the
Mode to Cool and the Fan to Low with the
temperature set in the middle.
NOTE: If the air conditioner is off and is then
turned on while set to a Cool setting or if
turned from a fan setting to a Cool setting, it
may take approximately 3 minutes for the
compressor to start and cooling to begin.
• Energy Saver Mode - Controls the Fan
On - The fan will cycle on and off with the
compressor. This results in wider variations of
room temperature and humidity. Normally
USING YOUR AIR CONDITIONER
used with the room is unoccupied. NOTE:
The fan may continue to run for a short time
after the compressor cycles off.
Off - The fan runs all the time in fan or
cooling mode.
• Fan Only Mode: Use Fan Only mode at Low,
Med, or High fan speed to provide air circulation
and filtering without cooling. Since fan only
setting does not provide cooling, a Set tempera-
ture cannot be entered. The room temperature
will appear in the display.
NOTE: Auto Fan Speed cannot be used in Fan
Only mode.
• Loss of Power Protection: If power to the air
conditioner is lost or interrupted, the air condi-
tioner will automatically re-start in the setting
last used prior to power loss. If the Timer was
set to automatically turn the air conditioner off or
on, it will resume countdown at the amount time
left prior to power loss. You may need to set a
new time if desired.
• Air Direction: Use the lever on the front air
vents to adjust the direction of the airflow. You
can direct the airflow left, right, up or down. The
lever is located on the right side of the air vent.
Fan direction adjusting rod
Air outlet frame
Advertisement
