Installation Instructions - pro-drive SHALLOW WATER OUTBOARD Motor Owner's Manual

INSTALLATION INSTRUCTIONS

FAILURE TO FOLLOW THESE INSTRUCTIONS
MAY CAUSE TRANSOM BRACKET FAILURE NOT
WARRANTED BY PRO-DRIVE.
AFTER INSTALLING YOUR MOTOR ON THE BOAT TRANSOM USING THE
ALUMINUM SAVER PLATE SUPPLIED WITH THE UNIT, TORQUE THE
TRANSOM BOLTS TO 15 FT. LBS. OF TORQUE.
YOUR UNIT COMES WITH ALL THREAD BOLTS COMPLETE WITH SELF
LOCKING NUTS AND WASHERS. DRILL THROUGH TRANSOM AND INSTALL
THESE. 15 FT. LBS OF TORQUE IS REQUIRED FOR THESE ALSO. IF A TORQUE
WRENCH IS NOT AVAILABLE USE A 6" ADJUSTABLE WRENCH. USE A 7/16"
DRILL BIT.
DO NOT OVER TORQUE BOLTS
THIS PICTURE OF A UNIT CRATED FOR SHIPMENT SHOWS
THE ALL THREAD INSTALLED THROUGH THE TRANSOM
SAVER PLATE.
THE TOP HOLE LOCATED HERE IS A REAR VIEW OF WHERE
THE ALL THREAD IS TO BE INSTALLED. THERE ARE TWO ON
EACH SIDE
THE BOTTOM TRANSOM HOLES (THERE ARE ALSO TWO)
ARE LOCATED HERE. USING A 7/16" BIT DRILL THROUGH
TRANSOM AND INSTALL 3/8" BOLTS WITH FLAT WASHERS.
USE SILICONE WHEN INSTALLING THESE
4