Prop Re-Installation - pro-drive SHALLOW WATER OUTBOARD Motor Owner's Manual

PROPELLER RE-INSTALLATION
USING LOCKTITE MARINE GRADE ANT-
SEIZE OR NEVER SEIZE COAT THE ENTIRE
SHAFT.
INSTALL THE TAPERED BUSHING AS
SHOWN, MAKING SURE THAT IT IS FULLY
FORWARD AND BOTTOMING OUT AT THE
THREADS END. COAT THE OUTSIDE
DIAMETER OF THE BUSHING AS IN THE
ABOVE STEP.
INSTALL THE PROP BY HAND USING
GLOVES AND TIGHTEN THOROUGHLY. IT
IS NOT NECESSARY TO USE THE WRENC H
FOR THIS STEP. ONCE THE PROP IS ON
THE SHAFT, REPLACE THE PROP NUT AND
TIGHTEN BY USING 1-1/16" WRENCH.
12