Prop Removal; Propeller Removal - pro-drive SHALLOW WATER OUTBOARD Motor Owner's Manual

PROPELLER REMOVAL

*NOTE: DO NOT ENGAGE THE CLUTCH TO REMOVE THE PROP. DOING SO MAY DAMAGE
THE CLUTCH AND VOID CLUTCH WARRANTY.
ALWAYS DISCONNECT TO BATTERY BEFORE ATTEMPTING TO REMOVE THE
PROPELLER OR ANY OTHER WORK OR SERVICE ON YOUR UNIT.
REMOVE THE CLUTCH COVER WRAP
AND LOCATE THE HOLE STOP AS
SHOWN ON LEFT. INSERT ½" BOLT
OR PROP PIN INTO THE HOLE STOP.
(THE PIN WILL PUSH UP AGAINST
THE PLATE POST AS BACK UP WH
UNSCREWING THE PROP.) *NOTE:
THE PROP UNSCREWS TO THE LEFT.
HOLE
STOP
REMOVE PROP NUT USING A 1-1/16"
WRENCH OR DEEP WALL SOCKET.
NEXT, INSTALL THE PROP WRENCH
AS SHOWN . REPLACE NUT TO
ENSURE THAT THE PROP WRENCH
WILL NOT SLIP OFF WHEN
REMOVING PROP. TURN THE
WRENCH COUNTER CLOCKWISE
UNTIL THE PROP IS REMOVED.
ILE
10