Securing the dishwasher
The dishwasher must be secured to the worktop, this can be done in
one of two ways:-
o Standard worktop- Secure the dishwasher to the underside of the
worktop by using two wood screws.
o You should screw through the holes in the brackets at the top of the
dishwasher cabinet.
o These screws should be fully tightened.
o Marble/granite worktop- The material of the worktop will mean
that it is impossible to put a screw through the underneath of the
worktop.
o On either side of the front edge of the dishwasher cabinet, there is
a rubber stopper. You should remove the rubber stoppers, to reveal
a pre-drilled hole on either side of the dishwasher.
o Secure the dishwasher to the cupboard either side of it, by screwing
a wood screw through the pre-drilled holes into the cupboards.
These screws should be fully tightened.
o The rubber stoppers should then be refitted into their original
position.
o Use a spirit level to
check
that
appliance is level.
o Check
that
appliance
is
from side to side.
o Check
that
appliance
is
from front to back.
the
the
level
the
level
35