Table of Contents
Advertisement
IP Control Unit
Installation Guide
Revision 1.0 Dated 20 June 2005
8701
Item
Link LED
Activity LED
Item
CL
A connection between this point and ground (▼) signifies a closed loop, once this
connection is broken from ground then an alarm will trigger if required. If this
P3
Bi-directional connection to the first RS232 controlled device. Connect the 'TX' to
the 'RX' of the device to control and the 'RX' to the 'TX' of the device to control
P4
Bi-directional connection to the 2nd RS232 controlled device. Connect the 'TX' to
the 'RX' of the device to control and the 'RX' to the 'TX' of the device to control
Connecting the IP Control Unit to a network
When you first receive your IP Control Unit, it is configured to obtain it's network IP address, subnet mask
and default gateway via DHCP. Follow the procedures listed below that best describe the situation that you
are installing the Control Units into.
3.1 Connecting the Control Unit via a crossover cable
Before connecting the IP Control Unit to the computer check that the PC's network connection is set to
'Obtain An IP Address Automatically'.
Click - Start
Click - Control Panel
Double Click - Network Connections
Select - Local Area Connection
Right Click and Select - Properties.
Click - Internet Protocol (TCP/IP)
Select - Properties
Select the first option - Obtain An IP Address Automatically
Tel: +44 (0)1442 242 224
E-Mail: technical@procon.co.uk
Indicator to show that the interface is connected to a network
Indicator blinks when data is being sent / received over the network
Description
feature is not used then this connection can be left unused.
with the ground connections commoned together.
with the ground connections commoned together
- 5 -
Description
www.procon.co.uk
Advertisement
Table of Contents
