VuQube V20 Installation And Operating Instructions Manual page 6

ANTENNA UNIT LOCATION AND INSTALLATION (FIG 3.)
IMPORTANT! The antenna unit MUST be mounted to the air ride cab, NEVER to any structure mounted
directly to the frame (for example the headache rack). Mounting directly to the frame will
void the VuQube warranty.
3. Determine the location of the antenna unit using the following criteria:
a) The antenna unit is designed to be mounted to a vehicle with an appropriate
mounting bracket such as the MB100 or MB200 (sold separately - for more
information call King Controls or visit our website at www.kingcontrols.com).
b) The antenna unit requires a 16" wide space for mounting.
c) It is highly recommended that the antenna unit extend a minimum of 4" above the
highest point of the cab or air shield for optimum satellite reception.
If you are unable to mount the antenna unit 4" above the cab due to height
restrictions, install with maximum clearance available. If the antenna unit is not high
enough, you may experience difficulty acquiring the satellite signal.
d) The antenna unit should be as far as possible from objects like smoke stacks,
beacons, logistic units, etc. that can physically block the satellite signal.
e) The wiring from the antenna unit may be run down the back of the cab and up into
the cab through an access bay, or a hole may be drilled in an appropriate location.
There must be no sharp bends in the wiring.
Fig. 3
The antenna unit MUST be mounted to the
air ride cab, NEVER to any structure
mounted directly to the frame.
Page 4
IMPORTANT