STEP 2: DIRECTV ANTENNA CONFIGURATION
The VuQube is factory pre-set for the DIRECTV 101 satellite. Unless the antenna has been
configured for another option since leaving the factory, PERFORM STEP 5 ONLY.
1. On the VuQube controller, press and release the
ON button. Wait for the status light to flash orange,
and then WAIT 4 MORE SECONDS.
2. Press and release the ON button 16 times.
The status light starts rapidly flashing green and red.
3. Press and hold the
The status light will turn orange for 1 second,
and then start flashing green or red.
4. Press OFF.
5. Set your receiver for round dish-1 satellite (do this through the receiver's
satellite set-up menu screens). Configuration is complete. Go to page 20.
1. On the VuQube controller, press and release the
ON button. Wait for the status light to flash orange,
and then WAIT 4 MORE SECONDS.
2. Press and release the ON button 8 times.
The status light starts rapidly flashing green and red.
3. Press and hold the
The status light will turn orange for 1 second,
and then start flashing green or red.
4. Press OFF.
5. Set your receiver for oval dish-2 satellites (do this through the receiver's
satellite set-up menu screens). Configuration is complete. Go to page 20.
Page 12
Single Satellite 101
button for 4 seconds.
DIRECTV Plus (satellites 101, 119)
button for 4 seconds.