Table of Contents
Advertisement
PARTS NAMES
1
AC input socket (AC INPUT)
Connect the AC power cord (supplied) securely to this socket
and to a wall outlet.
2
Video input terminals (VIDEO IN)
These terminals are used to input a video signal source to
this monitor.
Connect to the video output of a VCR or another monitor (for
loop through connection) or to a video camera.
3
Video output terminals (VIDEO OUT)
These terminals are used to output a video signal from this
monitor.
Loop-through output of the video in BNC connector, then
connect to the video input of another monitor or a VCR.
4
Termination Switch (HI/75Ω (Lo))
Select the input impedance (HI/75Ω).
When using only one monitor, turn the termination switch to
the 75Ω position. When using more than one monitor, set all
of the termination switch on the monitors to the HI position.
However, the last monitor termination switch should be in the
75Ω position for proper line termination.
CONNECTION
Before connecting your system, make sure that all units are turned off.
The picture signal source can be connected to either the A or B terminal at the rear of the monitor. The monitor selector switch at the
front of the monitor can be used to select the input terminal used.
Single Connection
To Video B
INPUT terminal
(Video signal cable)
Monitor
To Video A
INPUT terminal
(Video signal cable)
Video recorder
Video camera
Note: The components and connection cables are not included and must be purchased separately.
5
Sub-brightness control (SUB-BRI)
Turn to adjust picture brightness.
6
Vertical Size control (V-SIZE)
Turn to adjust picture vertical size of the picture.
7
Vertical hold control (V-HOLD)
If the picture is scrolling up or down on the screen, turn this
control until there is a single steady picture.
(Rear panel)
4
To Video input
terminal
To Video input
terminal
Monitor
Video recorder
Advertisement
Table of Contents
