BandLuxe K530 Series User Manual page 57

Electric Current
Load (Amps)
3-10
11-20
21-35
3. To avoid problems caused by corrosion and other imperfections, use a
dedicated ground wire instead of direct attachment to chassis ground.
4. To minimize noise interference, implementation of isolation or filters
among the router and other electrical devices is recommended.
5. Ensure that your K530 is securely mounted on the vehicle. In addition
to electrical requirements, also consider vibration and temperature
factors when choosing the optimal location for mounting your K530. If
vibration problem is noticeable, anti-vibration rubber grommets may
be used to reduce shock on your K530. Also avoid mounting your
K530 near a spot subject to extreme heat, such as a poorly ventilated
spot that is near the engine or is prone to direct sunlight.
6. To connect the device to USCC network, antennas connection to
LTE1 and LTE2 ports are required.
7. To utilize WiFi connection, antennas connection to WiFi1 and WiFi2
ports are required.
8. To utilize both LTE/CDMA and WiFi, all four antennas connection are
required.
9. GPS antenna is not mandatory unless LBS functionality is needed.
10. If only 1 antenna is connected to LTE/CDMA or WiFi, please always
connect the antenna to LTE1 and WiFi1. Wireless performance is
degraded in such scenario.
55
Appendix A: Vehicle Installation Guide
AWG Rating
10-Feet Cable
14 AWG
14 AWG
8 AWG
20-Feet Cable
12 AWG
10 AWG
6 AWG