Table of Contents
Advertisement
GB
•
If any, remove the batteries' isolating strips on the lid of the battery compartment (8)
or remove the protective sheets of the batteries and insert them by a placing the poles
correctly. If the scales does not display any funds from, remove the batteries and place
them back again. The LCD display (1) displays the content shown in the figure below.
•
Close the battery compartment (8) and wait for the LCD display (1) to display the content below.
SELECTInG THE unIT oF MEASurEMEnT
•
Press the UNIT button (7) [Fig. 3] to select the unit of measurement (kg/lb and cm/ft). Each
time it is pressed, the LCD display changes the unit of measurement shown (1):
SELECTInG THE uSEr
•
Press the USERS button (3) to activate the user selection mode. "P1" will start to flash on
the display.
•
Press the USERS button (3) to switch to the next users - "P2", "P3", "P4", "P5" - until your
reference number is displayed.
•
The height and age of the user will be displayed for 2 seconds and then the scales will be
set to 0.0Kg.
•
If you wish to change user, repeat the procedure as illustrated above.
4
Advertisement
Table of Contents
