Level & Install Leveling Information; Installation; Relocating The Shelves; Installation Troubleshooting - U-Line U-3018WCOL-00 Install Manual

10
10 Level & Install
Leveling Information
It is recommended that the unit is level once installed.
1. Use a level to check the levelness of the unit from front to back
and from side to
side. Level should be
placed along top
edge and side edge as
shown.
2. If the unit is not level,
remove grille and adjust feet as necessary. Use included tool to
adjust the height of the rear leveler feet. Turn screw clockwise to
raise the rear foot, counter-clockwise to lower.
3. Check the levelness after each adjustment and repeat the
previous steps until the unit is level.
Adjustment
Screw
Rear Level Foot
Rotate Forward Feet to Adjust
INSTALLATION TIP
If the room floor is higher than the floor in the cut-out opening,
adjust the rear feet to achieve a total unit rear height of 1/8" less
than the opening's rear height. Shorten the unit height in the front
by adjusting the front feet. This allows the unit to be gently tipped
into the opening. Readjust the front feet to level the unit after it is
correctly positioned in the opening.

Installation

1. Plug in the powercord.
2. Gently push the unit into position. Be careful to not entangle the
electrical cord.
3. Re-check the leveling, from front to back and side to side. Make
any necessary adjustments. The unit's top surface should be
approximately 1/8" below the countertop.
4. Install the 6 cabinet mounting screws for the Anti-tip bracket.
5. Remove the tape from the glass shelves and wipe out the inside
of the unit with a clean, water-dampened cloth.

Relocating the Shelves

The glass shelves can be moved to accommodate your bottles,
cans and containers.
Glass Shelves
• Open door fully, grasp shelf firmly, lift front edge slightly, and
pull straight out.
• Remove shelf tabs and reposition as necessary.
• Reinsert shelf into cabinet and set down onto shelf tabs.
• All four shelf tabs must be set to the same height to properly
support the weight of the shelf.

Installation Troubleshooting

Q:
Problem
The door remains open unless it is pushed closed.
A:
Solution
The hinges should be self-closing when the door is open
Adjustment
approximately 8". If this is not the case, make sure nothing is
Screw
Rear Level Foot
caught in the hinge closing mechanism. Also, re-check leveling from
front to back of the unit and readjust if necessary. Make sure that
pivot plate is installed correctly.
Q:
Problem
The custom overlay door was designed to align with the rest of the
cabinet doors, but the unit has crept forward.
A:
Solution
Make sure that the electrical cord is not obstructing the
installation.
Level & Install Unit 13