Radio Operations; Tuning To Radio Stations; Changing Tuning Grid; Presetting Radio Stations - Philips HTS3548 User Manual

Radio Operations

Before you start ...
Make sure the FM and AM/MW antennas
are connected. are connected.

Tuning to radio stations

A
Press SOURCE repeatedly until 'FM'
appears on the display panel (or press
RADIO on the remote control).
B
Press
start tuning.
The frequency indication starts to
change until a radio station with suffi cient
signal strength is found.
C
Repeat step
the desired radio station
D
To fi ne-tune the reception of a weak
station, press
repeatedly until an optimal reception is
found.

Changing tuning grid

(only applicable for certain regions)
In some countries, the frequency step
between adjacent channels in the (AM/
MW)/ FM band is 9 kHz/ 50 kHz (10 kHz/
100 kHz in some areas).
Note:
Changing the tuning grid erases all
previously stored preset radio stations.
A
Press SOURCE repeatedly until 'FM' or
'AM/MW' appears
B
Press x.
C
Press and hold u until 'GRID 9' or
'GRID 10' appears.
44
Downloaded From TheatreSystem-Manual.com Manuals
antennas
/ on the remote control to
B
if necessary until you fi nd
/ briefl y and

Presetting radio stations

You can store up to 40 FM and 20
AM/MW preset radio stations in the
memory. There are three different ways
to program the radio stations:
– Using auto install (for fi rst time setup
only)
– Using automatic preset
– Using manual preset
Helpful Hints:
– This unit exits presetting mode if no
button is pressed within 20 seconds.
– If no stereo signal is detected or less than
5 (fi ve) stations are detected during radio
installation, 'CHECK ANTENNA' appears.

Using auto install

When you access the 'RADIO' mode for
the very fi rst time, you will be prompted
to install the radio stations. With this
feature, you can install all the available
radio station automatically with one
touch of button.
ZOOM
A
Press RADIO.
'AUTO INSTALL ... PRESS PLAY'
appears.
RADIO