Radio Operations; Tuning To Radio Stations; Changing Tuning Grid - Philips HTS3365X/78 Manual

Before you start .....
Ensure that the antennas are connected
to the main unit. (For some models, the
FM antenna has been connected in the
factory.)
For FM antenna
A
Connect the FM antenna (supplied) to
the FM socket.
B
Attach the other end of the FM antenna
to a wall.
For AM/MW loop antenna
A
Stand the AM/MW loop antenna
(supplied) upright to fi x its claw into the
slot.
B
Connect the AM/MW loop antenna to
the AM/MW socket.
C
Place the AM/MW loop antenna on a
shelf, or attach it to a stand or wall.
AM/MW
loop antenna
Helpful Hints:
– For better FM stereo reception, connect an
external FM antenna (not supplied.)
– Position the antenna as far away as
possible from your TV, VCR or other
radiation source to prevent any unwanted
interference.

Tuning to radio stations

A
Press SOURCE repeatedly until 'FM' or
'AM/MW' appears on the display panel
(or press RADIO on the remote
control).
B
Press
start tuning.
change until a radio station with suffi cient
signal strength is found.
C
Repeat step
the desired radio station
D
To fi ne-tune the reception of a weak
station, press
repeatedly until an optimal reception is
found.

Changing tuning grid

(only applicable for certain regions)
FM
In some countries, the frequency step
antenna
between adjacent channels in the
(AM/MW) / FM Band is 9 kHZ / 50 kHz
(10 kHz / 100 kHz in some areas).
Note:
Changing the tuning grid erases all
previously stored preset radio stations.
AM/
MW
A
Press SOURCE repeatedly until 'FM' or
'AM/MW' appears.
B
Press x.
C
Press and hold u until 'GRID 9' or
'GRID 10' appears.

Radio Operations

/ on the remote control to
The frequency indication starts to
B
if necessary until you fi nd
/ briefl y and
47