tivate the appliance.
AUTOMATIC SWITCH OFF
The function deactivates the appliance
• All cooking zones are deactivated (
• You do not set the heat setting after you
activate the appliance.
• You spill something or put something on
the control panel for more than 10 sec-
onds, (a pan, a cloth, etc.). An acoustic
signal sound some time and the appli-
ance deactivates. Remove the object or
clean the control panel.
• You do not deactivate a cooking zone or
change the heat setting. After some time
comes on and the appliance deacti-
vates. See below.
• The relation between heat setting and
times of the Automatic Switch Off func-
THE HEAT SETTING
Touch the control bar at the heat setting.
Change to the left or the right, if it is neces-
sary. Do not release before you have a cor-
rect heat setting. The display shows the
DEACTIVATION OF THE OUTER
You can adjust the surface you cook to the
dimension of the cookware.
for 1 second to activate or deac-
— 6 hours
— 5 hours
— 4 hours
— 1.5 hours
To activate the outer ring touch the sensor
For more outer rings touch the same sen-
sor field again. The subsequent indicator
Do the procedure again to deactivate the
outer ring. The indicator goes out.
AUTOMATIC HEAT UP
You can get a necessary heat setting in a
shorter time if you activate the Automatic
Heat Up function. This function sets the
highest heat setting for some time (see the
diagram), and then decreases to the nec-
essary heat setting.
To start the Automatic Heat Up function for
a cooking zone:
Immediately touch the necessary heat
setting. After 3 seconds
in the display.
To stop the function change the heat set-
2 3 4 5 6 7 8 9 10 11 12 13 14
Count Down Timer
Use the Count Down Timer to set how long
the cooking zone operates for only this one
Set the Count Down Timer after the se-
lection of the cooking zone.
You can set the heat setting before or after
you set the timer.
. The indicator comes on.
comes on in the dis-