Mitsubishi Electric MR-C375C-W-A Service Manual page 22

OPERATING PROCEDURE
3. Detachment the Vegetable case parts
(1) Detach parts inside vegetable compartment (Vegetable case, Fruit case).
(2) Detach the door of vegetable compartment.
(3) Detach rivet (C) at the right and unhooking 2 catches at front,
(center and left). (Photo 5)
Caution on assembly
[1] Be sure to put vegetable case cover on the catches at the rear of
vegetable compartment.
Water pump motor
(4) Remove two screws and cut the lead wire of water-pump motor to
detach it.
4. Detach the refrigerator room parts
(1) Detach parts inside the refrigerator compartment.
(2) Detach parts inside the vegetable compartment.
(3) Detach a left screw of mirror hinge and pull out the lead wire.
(Photo 7)
(4) Detach the connector.
Control panel , Duct R, Temperature control panel
(5) Remove the upper and lower rivets (C) of right side and left side,
then unhook 7 catches.(9 catches for C405B)
* Remove the right catch before push the control panel to the right
and detach it. (Photo 7)
Fan grille
(6) Remove the following; Screw (A) at the upper and right center,
2 screws (B) at the left and 2 screws (B) at the right. (Photo 6)
* Motor damper and thermal fuse are combined with fan grille.
* Fan and fan motor are combined with fan grille.
Caution on assembly
[1] Use new tapes and sealing materials for assembly.
[2] Putting some tape across joints, tape them securely so that they will
not leak the cool air.
[3] Attach a connector securely in order to prevent contact failure.
Photo 5
Catches
V-room
Photo 6
Screw
Photo 7
Catch
Catch
(only:C405B)
Catch
Rivet
20
PHOTOS
Vegetable
case cover
Rivet
Catch
Catch
Screw
Fan grille
F-room
Catch Catch
Catch
Rivet
Rivet
Lamp
Catch
Screw
Control panel
Catch
(only:C405B)
Catch
Rivet
R-room
Mirror hinge