Step 3: Connecting Your Tv - Sony SAT-A55P Service Manual

Step 3: Connecting Your TV

Digital Satellite Receiver
2a If your TV has A/V input
jacks
Connect the VIDEO OUT
jacks on your Digital
Satellite Receiver to the
A/V input jacks on your TV
using the supplied A/V
cable. (Be sure to match the
colors on the jacks with the
colored plugs on the A/V
cable.)
If your TV has an S-Video
2b
input
Use an S-Video cable
instead of the yellow video
connection. S-Video cable is
supplied with the SAT-A55
model and is an optional
accessory with the SAT-B55
model.
If your TV has only one
audio input, connect it to
the L(MONO) jack on the
receiver.
Connect your TV to the Digital Satellite Receiver as shown below. Refer
to your TV's instruction manual for more information.
2a
VIDEO
(yellow)
A/V Cable
OR
S-Video
TV
-AUDIO-
If you have a local TV antenna or cable
1
company service
Connect it to the VHF/UHF IN jack on your Digital
Satellite Receiver using a coaxial cable or RF
adapter (not supplied).
You can view local stations using your TV controls.
Note
You must use the VHF(SAT)/UHF OUT jack to
connect to your TV or VCR when a local TV antenna
or cable company service is connected to the
VHF/UHF IN jack (see "2c" below and on page 10).
Coaxial
Cable
1
2b
2c
S-Video
Cable
If your TV does not have
2c
A/V jacks
Coaxial
Connect the VHF(SAT)/UHF
Cable
OUT jack to the VHF/UHF
input jack on your TV using
coaxial cable.
Set the CH3/CH4 switch to the
channel that does not carry off-
air broadcasts in your area.
Note
With this connection, your
input source is channel 3 or
channel 4 depending on how
you set the CH3/CH4 switch
on the receiver.
9