Sony SAT-A55P Service Manual page 66

Setting Up Your Digital Satellite Receiver (SYSTEM)
(continued)
z
Tip
Selecting "off" in the SignalSeeker
pop-up may allow you to see the
Signal Strength Meter if you use a
diplexer or certain other accessories
with your Satellite Dish Antenna.
Note
The SignalSeeker feature is available
only with the Round Antenna. Refer to
your Satellite Dish Antenna
Installation Instructions for more
information about this feature.
24
Selecting an Antenna Type
The Antenna Type display lets you or your professional installer enter
which type of Satellite Dish Antenna you use. After you have entered
your antenna type, you can use the Antenna Location pop-up to help aim
your antenna.
1
Highlight and select "Antenna Type" from the Antenna
Display.
The Antenna Type display appears.
2
Highlight and select the Satellite Dish Antenna type that
you have installed.
The SignalSeeker pop-up appears if you have selected "Round".
Skip to step 4 if you selected "Oval 2-Sat" or "Oval 3-Sat".
3
Highlight and select "On" if you selected "Round".
The SignalSeeker pop-up closes to show the Antenna Type display.
4
Select "Return".
The Antenna Type display closes to show the Antenna display.