PEUGEOT Vivacity Workshop Manual page 30

SERVICE OPERATIONS
Reassembly.
Lubricate the brake cam and fit it into
the casing.
- Fit the brake arm onto the cam and align
the punched marks. (A)
Tightening torque: 6 Nm.
- Slightly lubricate the brake cam and pin.
- Install the grake linings.
- Install the spring (9).
- Install the brake control cable, the barrel
and the adjusting nut. (5)
- Install the wheel.
Tightening torque: 100 Nm.
- Measure the free travel of the rear brake
control lever.
- Ajust the lever free travel using the
adjusting nut.
B. Brake control free travel: 10 to 20 mm.
- Install the exhaust.
N
Use a new exhaust gasket.
• Exhaust to cylinder mounting nut:
Tightening torque: 15 Nm.
• Exhaust to casing mounting bolt:
Tightening torque: 20 Nm.
28
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
9
B
8
5
A