Table of Contents
Advertisement
Connections
Tips
Depending on your TV and other equipment you wish
to connect, there are various ways you could connect
the player. Use only one of the connections
described below.
Please refer to the manuals of your TV, VCR, Stereo
System or other devices as necessary to make the
best connections.
For better sound reproduction, connect the player's
AUDIO OUT jacks to the audio in jacks of your
amplifier, receiver, stereo or audio/video equipment.
See "Connecting to Optional Equipment" on page 11.
Caution
– Make sure the DVD Player is connected directly to the
TV. Tune the TV to the correct video input channel.
– Do not connect the DVD Player's AUDIO OUT jack to
the phono in jack (record deck) of your audio system.
– Do not connect your DVD Player via your VCR. The
DVD image could be distorted by the copy protection
system.
Connecting to a TV
Make one of the following connections, depending on
the capabilities of your existing equipment.
When using the COMPONENT VIDEO OUT jacks,
set the VIDEO OUTPUT switch to COMPONENT.
When using the SCART jack, set the VIDEO OUT-
PUT switch to SCART.
Video connection (Good)
1 1
Connect the VIDEO OUT jack on the DVD Player to
the video in jack on the TV using the video cable (V).
2
Connect the Left and Right AUDIO OUT jacks of
the DVD Player to the audio left/right in jacks on the
TV (A) using the audio cables.
S-Video connection (Better)
1 1
Connect the S-VIDEO OUT jack on the DVD Player
to the S-Video in jack on the TV using the S-Video
cable (S).
2
Connect the Left and Right AUDIO OUT jacks of
the DVD Player to the audio left/right in jacks on the
TV (A) using the audio cables.
Component Video (ColorStream
1 1
Connect the COMPONENT VIDEO OUT/
PROGRESSIVE SCAN jacks on the DVD Player to
the corresponding in jacks on the TV using the
Y Pb Pr cable (C).
2
Connect the Left and Right AUDIO OUT jacks of
the DVD Player to the audio left/right in jacks on the
TV (A) using the audio cables.
SCART connection
Connect the TO TV scart jack on the DVD Player to the
corresponding in jacks on the TV using the scart cable (T).
Progressive Scan (ColorStream
1 1
2 2
– Set the Progressive to "On" on the setup menu for
– Set the Progressive to "Off" by removing any disc
– Progressive scan does not work with the analog video
®
) connection (Best)
If the TV has an S-video input, connect the DVD player
with the S-video cable. When using an S-video cable,
do not connect the yellow video cable.
1-10
If your television is a high-definition or "digital ready"
television, you may take advantage of the DVD
Player's progressive scan output for the highest
video resolution possible.
If your TV does not accept the Progressive Scan for-
mat, the picture will appear scrambled if you try
Progressive Scan on the DVD Player.
Connect the COMPONENT VIDEO OUT/
PROGRESSIVE SCAN jacks on the DVD Player to
the corresponding in jacks on the TV using the
Y Pb Pr cable (C).
Connect the Left and Right AUDIO OUT jacks of
the DVD Player to the audio left/right in jacks on the
TV (A) using the audio cables.
Notes
progressive signal, see page 14.
from the unit and close the disc tray. See that "no
disc" is displayed on the display window. Then press
STOP and hold it for five seconds before releasing it.
connections (yellow VIDEO OUT jack) or S-VIDEO
connection.
Rear of TV
S-VIDEO
COMPONENT VIDEO /
AUDIO INPUT
PROGRESSIVE SCAN INPUT
INPUT
Y
Pr
Pb
R
L
C
S
A
Note
®
Pro) connection
SCART INPUT
VIDEO
INPUT
V
T
Rear of DVD player
Advertisement
Table of Contents
