D-Link DSM-G600 Installation Manual page 7

Wireless network storage enclosure

Hide thumbs Also See for DSM-G600:

Table of Contents

DSM-G600 Install Guide

Installing the Hardware (continued)

While facing the back of

the DSM-G600, inser t

the right side of the hard

drive into the case. Once

in place, snap down the

left side.

Use the mounting screw to

secure the hard drive to the

DSM-G600. Replace the

cover and screw the two

screws on the back panel

of the DSM-G600.

Connect an Ether net

cable to the Ethernet port

located on the back of the

DSM-G600.

Note: It is required that an Ethernet cable is used during initial setup. Once

your wireless conﬁguration is set, you may disconnect the Ethernet cable and

begin communicating wirelessly with your DSM-G600.

D-Link Systems, Inc.

Installing the Hardware

Table of Contents