Hardware Overview; Leds And Buttons - D-Link mydlink DSP-W215 User Manual

Section 1 - Product Overview
1 WPS Button
2 System Status LED
3 Power Plug
4 Reset Button
5 Power Socket
Power Button /
6
Status LED
D-Link DSP-W215 User Manual

Hardware Overview

LEDs and Buttons

1
2
Press for one second to start the WPS connection process. The System Status LED will start to blink green.
Solid Green
Blinking Green
Blinking Orange
Solid Red
Light Off
Plug the Smart Plug into a wall power socket.
To reset the device to factory defaults, press and hold for about 10 seconds until the Status LED turns red.
Connect your appliances, lamps, and other electronic devices you wish to monitor.
Press the power button to turn the connected device on or off. The LED will be solid green if the device is powered on.
3
4
The uplink is established and an IP is provisioned.
WPS is activated.
The uplink is not established or an IP is not provisioned.
The device is powering on or is defective.
The device is powered off.
5
6
4